NX-100 Network Audio Adapter

The NX-100 Network Audio Adapter satisfies the requirements for transmitting high quality audio signals and control signal as serial data over networks using the IP protocol in real time. These include the internet and LANs and allow significant cost reductions when transmitting audio signals to various remote areas as costly dedicated lines do not have to be used. If there is no network delay, audio signals have only a
minimal millisecond delay.
Control data including contact and serial data can also be
transmitted along with the audio signals.
Two-way audio signal transmission is possible with a single
NX-100 unit as every unit is equipped with an audio input and output.
The multicast-capable NX-100 allows simultaneous
transmission of audio signals to be made to multiple
locations depending on transmission method:
Unicast — up to 4 locations,
Multicast — up to 64 locations.
No audio signal degradation or loss, even when
transmitting over crowded networks such as the internet.
Greater data reliability using IP networks with the protocol's
ability to prevent data problems during transmission.
The NX-100's contact input can initiate and terminate
audio transmissions without having to use dedicated
control equipment such as a PC.
Hardware use ensures operational reliability over only
software-driven applications.
Using IP to transmit audio signals over the internet allows low
cost operation rather than dedicated lines.
The NX-100 is equipped with a DC input to allow operation on
AC as well as DC.
Software-driven operational menus enhance ease of use.